(5kg ,10kg ,20kg) 每桶
Specifications:
(5kg ,10kg ,20kg) per Bucket
產品說明
Product De
kII通用型柔性防水涂料是專門針對地下室、衛生間等建筑物的迎水面和背水面防水而研制的防水材料。該材料由液料和粉料組成,成形后即具有聚合物材料的防水性和抗?jié)B性,又具有水硬性膠凝材料的高強度性、強粘結力性、耐水性等優點,是理想的建筑專用防水材料。
KII universal flexible waterproof coating is a waterproof material specially developed for the waterproofing of basement, toilet and other buildings on their water surface and back side. This material is composed by materials of powder and liquid. After forming, it not only has the waterproof and impermeability of polymer material, but also has the advantages of high strength, strong adhesion and water resistance of hydraulic cementing material, so it is an ideal waterproof material for buildings
產品特點
Product Features
1. 可在液態下施工;能在室溫下固化;操作簡單;工期短。
Construction can be processed in liquid state; It can solidify at normal temperature; operation is simple; working period is short.
2. 能在潮濕及復雜的多種材質基面上施工,涂膜整體性強。
Can be constructed on wet and complex base surface of various materials, and the coating film has strong integrity.
3. 強度高、粘結力強,滲透性好,具有非常好的耐水性。
It has the properties of high strength, strong adhesion, good permeability, good water resistance.
4. 以水為介質,綠色健康。
It takes water as it medium. Its a green & healthy product.
適用范圍
Scope of application
適用于室內外的水泥及混泥土結構、磚墻結構的地下室、隧道、水庫大壩、水池、衛生間、浴室、地面等處的防水、防潮、防滲工程。
Suitable for waterproof, moisture-proof, seepage prevention works of indoor and outdoor cement and concrete structure, brick wall structure basement, tunnel, reservoir dam, pool, toilet, bathroom, ground , etc.
施工說明:
Construction Guidance
1. 基面處理:基面要求平整、干凈、牢固、無滲漏、濕潤無明水。如果有凹凸不平及裂縫現象,需要先找平。
Base surface treatment:the base surface shall be flat, clean, firm, without leakage and open water. If there are irregularities and cracks, leveling is required first.
2. 將液料和粉料按比列攪拌成均勻狀態。
Mix material of liquid and powder into a uniform state proportionally.
3. 用刷子或滾筒將漿料均勻的在處理好的基面上涂刷。施工過程中保持間歇性的攪拌,以防沉淀。
Brush slurry evenly on the treated base surface with a brush or drum. Keep intermittent stirring during construction to prevent precipitation
4. 做完第一遍后必須等待其略為干固后再做第二層,干固標準是剛好不粘手,一般需要1~2小時。如果第一層完全干透后再施工第二層時,應該噴灑少量清水,保持基面濕潤。
After the first brush completed, must wait until it become a little dry , the standard is just not hand-sticky, generally takes 1~2 hours. If its dry completely, which beyond the level to commit the second brush, should spray a little water to make it wet.
5. 每一層不宜刷的太厚,以便利于養護和固化。施工完畢上一道工序后方可進行下一道工序。
Each layer should not be too thick to facilitate maintaining and solidifying. Construction procedures should be one by another. Don’t execute new procedure until the previous procedure was completed.
參考用量
Reference of Dosage
1.0mm-1.6~2.0kg/M2
1.5mm-2.4-3.0kg/M2
2.0mm-3.6-4.0kg/M2
注意事項
Attention
1. 施工溫度宜在5℃以上,雨天不能施工。
The construction temperature should be above 5℃, and construction cannot be carried out in rainy days.
2. 涂料在使用前需先將膠乳攪勻。如膠乳粘度大,可加適量的水進行稀釋。
The coating needs to be stirred evenly prior to use. If the latex is too viscous, Can be diluted with proper amount of water
3. 原裝密封產品應儲存在0℃以上干燥通風的倉庫,保質期12個月。
Original sealed products should be placed in a warehouse where the temperature is zero above, dry and ventilated . The validity period is 12 months
4. 涂膜尚未固化前,應注意保護,禁止踩踏和堆放重物及尖銳物體。
Before the film is solidified, attention should be paid to the protection and prohibition of trample and stacking of heavy and sharp objects